This includes data packets send between other devices, something which is not possible unless your device is in monitor mode. Both involve putting the wireless LAN card into 'monitor mode', allowing you to view and record all packets sent by other WiFi devices nearby. I previously showed two ways to capture wireless LAN packets in Ubuntu Linux: using the command line tool iwconfig and using Kismet. Tils for Debian) 2.34) #1 SMP Debian 5.7.Capturing Wireless LAN Packets in Monitor Mode with iw beacuse of this i can't use any other tools like airgeddon,etcĮven if i turn-on monitor mode using the first method it just resets when i open airgeddon and wifi goes out the moment i start airgeddon Run /usr/sbin/airmon-ng without any arguments to see available interfacesĪs you can see if i ran the command again it just says wlan0 does not exist. (mac80211 station mode vif disabled for airmon-ng start wlan0 (mac80211 monitor mode vif enabled for wlan0 on wlan0mon) Phy0 wlan0 b43 Broadcom on bcma bus, information limited The card in monitor mode, they will interfere by changing channelsĪnd sometimes putting the interface back in managed mode Kill them using 'airmon-ng check kill' before putting and subsidiaries BCM43228 802.11a/b/g/n Īdn the site did't listed 4359 but the second one did so i tried to enable monitore mode ifconfig wlan0 iwconfig wlan0 mode ifconfig wlan0 upĪnd it worked so i did the 'injection test' in Īnd it gives me this aireplay-ng -9 wlan0

i cheked these forums, and found out my card support monitor mode the first one does't list my card cause if i lspci -vnn | grep 14e4Ġ5:00.0 Network controller : Broadcom Inc.

Broadcom monitor mode driver